Tips and tricks to install brick pavers

 

Here we will discuss some important tips about brick pavers that will help you to design the best patio pavers for your home. The first thing everyone notices while entering your home is your driveways or sideways. You should therefore pay them the same level of attention that you would give to your own home. In deciding what kind of paving product you would like to use for your paving areas, you need to consider a lot of things. 

Choosing the right one

Your local garden center or stone center would be a good source of sample brick pavers. You should learn what colors and styles are available for them and which style you think would fit your home. We recommend waiting until you have checked out the samples at home to make the final decision. Make sure you consider the colors of your shutters, doors, and siding.

Digging Paving Area

It will be necessary to dig a few inches below the final grade of your pathway. You will have 3-5 inches of the compacted base, made of stone dust and quarry-processed stone, below the brick paving layer so you can lay it and level it properly. A brick paver is generally between 2 ¼ and 2 ½ inches thick. You should also prepare an extra 6 inches for the edging materials on each side of the pathway in order to hold the pavers in place.

Base Layer Installation

Vibratory plate tampers are necessary for this step in the brick paving process. A local rental shop usually rents them for around $150 per day. It is recommended to set up the base by layering on the quarry processed stone every two inches and tamping thoroughly in between each layer.

Creating Pitch

As you build your brick paver pathway, it is very important to create the correct pitch to allow water to drain. The brick paver pathway is likely to be damaged if the pitch is not treated. Water is likely to accumulate on the brick pavers, so it’s important to make sure the pathway slopes away from the foundation and away from the brick pavers themselves. I would estimate two to three inches of pitch per ten feet of bricks. The lifespan of your brick pathway can be extended by years if you follow this rule.

Brick pavers installation

The pattern you want your brick pavers to have is likely something you decided upon when you chose them. Therefore, this is the stage where you go about creating it. Expert like Atlantic Brick & Stone recommends, making straight lines using strings will be helpful for following the pathway’s length. Pavers must probably be cut once the edges of bricks are laid. Concrete saws are required for this task. If you are interested in finding out which kind of saw will be appropriate for the job, you can check with your nearest rental shop.

Using the right edging material helps hold the bricks in place and keep them tight. It’s absolutely necessary for colder climates so that bricks don’t push apart, creating gaps due to thawing and buckling. Alternatively, you can use an invisible edge made from mixed concrete below the surface or edging materials made from aluminum or plastic equipped with spikes which can be found at local brick supply shops.

Fill Joints

In brick pavers, poly sand is the new material used to fill in joints. It becomes sticky when wet and hardens when it dries. By using this method, you will create a very tough bond between the brick pavers and prevent weed growth.

Leave a Reply

Your email address will not be published. Required fields are marked *